neck dimension question

View previous topic View next topic Go down

neck dimension question

Post by Guest on Fri Dec 17, 2010 11:01 pm

Would a Thunder bolt on neck fit in a pantera 300?
I have a strange project in mind where I'm looking to put a neck on an x300 that has the 3x3 tuner setup. I like the Thunder headstock, but have no access to see if they are compatible as a swap for the 300.

Guest
Guest


Back to top Go down

Re: neck dimension question

Post by bowenjaybee on Sat Dec 18, 2010 1:23 am

If the neck did fit, It would not work as the Pantera 300 is 25 1/2 inch scale and the Thunder is 24 3/4 inch scale (the bolt on version anyway)

bowenjaybee
Senior Member

Number of posts : 560
Age : 44
Location : Bradford, West Yorkshire . UK
Registration date : 2010-02-22

Back to top Go down

Re: neck dimension question

Post by Guest on Thu Dec 23, 2010 10:47 pm

I'm not too worries about the scale as this project means getting rid of the trem and putting a fixed bridge on, so I can adjust as needed.
Just looking to see if a 3x3 neck that exisits that would fit a x300 neck pocket.

Guest
Guest


Back to top Go down

Re: neck dimension question

Post by Sponsored content Today at 3:11 pm


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum