"Pre-wired" phase/coil switches (Thunder series active)

View previous topic View next topic Go down

"Pre-wired" phase/coil switches (Thunder series active)

Post by arcoddath on Wed Feb 23, 2011 10:58 pm

Has anyone ever found a source for the ready-made phase/coil-tap dpdt switches that were in the Thunder 1A guitars (and presumably the rest of the Thunder series) or is the solution the usual fiddling about with little jumper wires?

arcoddath
Registered Member

Number of posts : 5
Age : 47
Location : Edinburgh, Scotland
Registration date : 2011-02-23

Back to top Go down

Re: "Pre-wired" phase/coil switches (Thunder series active)

Post by The Guitar on Fri Feb 25, 2011 12:59 am

Have you looked at the Westone.info site? The only thing that I remember is the CL4112 diagram, but I think the Thunder diagrams are there.

The Guitar
Westone Nut

Number of posts : 36
Age : 34
Location : Lafayette, IN
Registration date : 2011-02-09

http://www.wix.com/bokkire_jin/bokkirejin

Back to top Go down

Re: "Pre-wired" phase/coil switches (Thunder series active)

Post by arcoddath on Fri Feb 25, 2011 11:35 pm

What I meant, and I was regrettably unclear, was has anyone ever found a supplier of phase reverse switches. Here's a picture of my Thunder 1-A's phase switch:



You can clearly see the printed connections on the baseplate of the switch -- normally it'd be a case of wiring up a familiar "X" shape across the contacts but this switch avoids all that and makes the wiring straightforward.

Any joy anywhere?

AxS

arcoddath
Registered Member

Number of posts : 5
Age : 47
Location : Edinburgh, Scotland
Registration date : 2011-02-23

Back to top Go down

Re: "Pre-wired" phase/coil switches (Thunder series active)

Post by Westbone on Sat Feb 26, 2011 4:23 am

No, never seen them elsewhere. Not rocket science though. Get you're arc welder. Laughing
Read note 2 below.
http://www.westone.info/wiring/thunderlead/active1/index.html

You could unsolder the little circuit board and resolder onto a new switch. These are available from Maplins and on ebay.

Westbone
Financial supporter

Number of posts : 4860
Location : Redbridge
Registration date : 2008-12-28

http://www.chruler.com/

Back to top Go down

Re: "Pre-wired" phase/coil switches (Thunder series active)

Post by Sponsored content Today at 8:14 pm


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum